Engineered for Global Grid-Constrained Facilities
GasXys
Next-Generation Thermal Engineering

High-COP Heating & Cooling
Without Power Grid Expansion

Industrial air-source gas engine heat pumps (GHP) and chillers. Designed for commercial facilities, industrial processes, and cold-climate facilities. Powered by natural gas or propane with 100% waste heat recovery.

1.8 PER
Total Primary Energy Ratio
-25°C
Continuous Non-Stop Defrost
-90%
Peak Electric Load vs EHP
GASXYS GHP ENGINE CORE
FUEL INPUT Natural Gas / LPG / Biomethane
Shaft Work Output
Drives Compressor
Engine Waste Heat
100% Water Heating
Solves the "Grid Bottleneck"

Eliminates 6-figure transformer upgrade fees in commercial retrofits. Requires less than 10% of the electrical capacity of comparable electric heat pumps.

Available in 70kW, 200kW, 420kW, 850kW, up to 1400kW modular skids

Engineering Benchmark

Why Modern Facilities are Transitioning to GHP

Comparing primary energy consumption, extreme cold resilience, and electrical infrastructure demands.

System Parameter Traditional Gas Boiler Commercial Electric Heat Pump GasXys Gas Engine Heat Pump
Primary Fuel Source Natural Gas / Fuel Oil 100% Grid Electricity Natural Gas / LPG / Biomethane
Primary Energy Ratio (PER) 0.85 – 0.95 1.0 – 1.3 (Degraded by grid losses) 1.4 – 1.8 (Engine Work + Thermal Recovery)
Performance at -20°C (-4°F) Constant (High ongoing fuel cost) Severe capacity drop (40%+ loss) Uncompromised output w/ Engine Coolant Boost
Defrost Operation Mode N/A Reverses cycle; water loop drops 5-10°C Continuous waste heat bypass; zero thermal interruption
Transformer & Substation Cost Negligible Very High ($50k – $300k+ upgrade fee) Zero substation expansion needed
Summer Chilled Water Option None (Requires separate chiller) Included Simultaneous / Switchable Chilled Water (7°C)

Equipment Lineup

Commercial & Industrial Gas Heat Pumps

Standardized modular units and heavy industrial skid designs. Custom configurations available for OEM / EPC partnerships.
Commercial Series 70kW – 210kW

Modular Air-Source GHP Unit

Ultra-quiet outdoor packaged heat pump for hotels, hospitals, and central commercial HVAC. Dual cooling and heating with continuous hot water.

Heating Output: 71kW / 210kW (240k - 716k BTU/h)
Leaving Water Temp: Up to 65°C (149°F)
Aux. Electric Power: 2.5kW – 5.5kW only
View Full Specs & BIM BACnet / Modbus
Heavy Industrial 200kW – 1400kW

Gas-Engine Screw Chiller / Heat Pump

Heavy-duty industrial screw compressor directly coupled to a low-NOx industrial engine. Ideal for district heating and industrial facilities.

Heating Output: Up to 1,360 kW (4,640 MBH)
Compressor: Semi-hermetic twin screw
Flue Economizer: Integrated Dual-Stage
Cold Chain & Agri -35°C Low-Temp

Gas-Driven Cold Storage & Freezing

Simultaneous sub-zero refrigeration for slaughterhouses, food logistics, and cold rooms, with free 80°C sanitation water recovered.

Evaporating Temp: -10°C to -35°C
Free Hot Water: 70°C – 85°C (100% Free)
Energy Cost Saving: 35% – 50% vs Electric
Review Case Specs Food Grade Ready
Engineering Decision Tool

Interactive TCO & Energy Savings Calculator

Simulate your facility's annual operational expense (OPEX) savings and estimated equipment payback period compared to an electric heat pump.

Project Thermal Parameters

Facility Heating Load Capacity: 200 kW
50 kW 500 kW 1000 kW
Local Natural Gas Rate: $1.20 / Therm
$0.60 (US Low) $1.80 (Average) $3.00 (EU High)
Commercial Electric Tariff: $0.20 / kWh
$0.08 / kWh $0.25 / kWh $0.50 / kWh
Annual Heating & Water Run Hours: 2,500 Hours / Year
Calculation assumptions: GHP integrated PER = 1.60; Baseline Electric Heat Pump seasonal COP = 2.40 (accounting for winter defrost penalty).
Simulation Output Currency: USD ($)
Estimated Annual Operating Savings:
$22,410

Reduction in annual utility bills compared to standard commercial electric heat pumps.

Estimated Payback Period:
1.8 – 2.4 Years
Annual CO₂ Abatement:
~ 42.5 Tons
Plus: Capital Avoidance: Saves an estimated $35,000 – $75,000 in primary transformer/substation upgrade fees if your facility has grid capacity limits.

Versatile Deployments

Target Applications Across Global Facilities

Hotels & Healthcare

Simultaneous space heating/cooling plus 24/7 domestic hot water (65°C) without requiring electric immersion heater boosters.

Food & Meat Processing

Sub-zero cold rooms paired with continuous high-temperature waste heat for sanitizing washdown water. Cuts operating costs by 45%.

Agricultural Greenhouses

Constant root-zone and canopy heating during harsh freezing nights. Clean natural gas combustion allows optional CO₂ enrichment.

Industrial Waste Heat

Extracts low-grade waste heat from industrial chimneys or effluents, boosting it to usable process steam or central district water.

Request a Project Sizing & Technical Quote

Share your facility's requirements. Our engineers will review your thermal load and deliver a preliminary equipment schedule, P&ID diagram, and TCO model.